Why water flows from the sole of the iron

A common problem in the operation of steam irons - instead of steam from the holes in the sole, water flows out. Why is this happening? The cause of the malfunction may be a violation of the rules of use, and the marriage of one of the details. Detect the source of the defect, and eliminate it in various ways.

Why do irons flow during work?

To understand this issue, you need to familiarize yourself with the principle of operation of the device, more precisely, the steam supply mechanism. The cause of the fault can be determined independently at the moment of manifestation.

Why irons can leak in the process of work:

• valve malfunction;
• non-compliance with the manufacturer’s instructions for use.

When the cause of the leakage of fluid from the bottom of the device is detected, it becomes clear what to do to eliminate it.

Iron device or what to do if valve is faulty?

The principle of operation of the iron: Water flows from the reservoir through the control valve to the inside of the sole. On the case of the steam ironing device there is a special regulator that increases or, on the contrary, reduces its openings so that the liquid gets to the working surface in a certain amount. Under the action of high temperature, it is converted into steam and exits through small holes located on the sole of the iron.

Even if the ironing device was used according to the manufacturer's instructions, the liquid can still flow out of the holes in the sole when the valve is completely closed and the temperature of the working surface of the device is low. The most likely cause of such a defect is valve malfunction. To make sure of this, you should pour water into the iron, turn off the steam supply, not including 220 V in the electric network, and chat a little in a horizontal position. If the water comes out of the device, it meansthat the valve tightly closes the holes for its supply.

This is an actual problem for many owners of this type of home appliances. The valve, which is responsible for adjusting the steam supply, has rubber elements - gaskets. With prolonged use under the action of high temperature, they become less elastic, which leads to leaky valve operation.

This type of damage should be handled by the master of authorized service centers, with appropriate qualifications.

Operation errors

Water from the device may flow if the instructions for use are not followed. This is the most common reason why water flows from an iron.

On the case of modern devices for ironing is a temperature controller with special marks that indicate when you can turn on the steam blow. If the sole of the device does not heat up to the optimum temperature for the formation of steam, liquid will flow out through the holes instead.

Before turning on the “Steam” function, put the heating regulator in the position corresponding to the type of fabric, set the iron vertically and wait until the indicator goes off indicating that it is ready for operation.

Otherwise, water will flow from the holes in the sole.If the heating regulator fails, contact an authorized service center for assistance. In the absence of a significant deficiency in the product, which cannot be eliminated, the repair will save the owners money, since it will cost many times cheaper than buying a new iron.

During ironing, the iron filler cap must be tightly closed (until it clicks) so that no water droplets fall onto the fabric.

Iron water leakage: preventing malfunction

If too much steam escapes, it may condense on the outside of the working surface of the device and leave wet marks on the fabric at the moment of contact with it. It refers to liquid leakage due to vapor condensation.

When the device is filled with water, additional components may be introduced, such as starch, chemicals, ironing additives, and others. This can delay the process of vaporization, facilitating the outflow of fluid. To eliminate this, it is necessary to rinse the compartment for water well, and in the future to prevent the ingress of foreign elements.To prevent this situation it is necessary apply distilled water.

If after cooling or during storage water flows from the iron, it means that it was installed horizontally and the tank remained filled.

After each use, it is necessary to drain the liquid from the ironing device and set the steam control to the “0” position. Store the device only vertically.

Follow these simple rules and you will not have to look for the answer to the question. "Why steam iron flows».