Malfunctions of the Zanussi washing machine and options for eliminating them

The following common malfunctions are observed in Zanussi washing machines, their elimination can be done by a master or with your own hands:

• difficulty pressing and draining;
• noises;
• problem with electronics.

Spin and drain

If the washing machine Zanussi does not drain completely and badly squeezes underwear (the display shows the codes E 21, E 23, E 24), the reason for this is most often blockage.

In the pump it is eliminated as follows:

1. The water supply valve is closed, the device is disconnected from the network.
2. Allow detergent to cool.
3. Open the basement panel.
4. Take out and open the drain hose of the pump of the machine.
5. Drain the water through it.
6. Plug and clean the hose.
7. Turn the pump cover counterclockwise.
8. Remove foreign objects.

Now the blades in the pump turn freely.Then tightly tighten the lid, fix in the same place the base panel. To check the work produced a test drain water.

Can also be clogged:

• filter (it is removed and washed thoroughly);
• a pipe connecting the pump to the tank;
• drain hose (it is felt and cleaned by the stuck object);
• siphon sink or sewer pipe.

In addition, the cause of incomplete draining machines Zanussi breakage of the following elements:

• pump;
• electronic module;
• team device

In this case, they are usually required to be replaced.

The device weakly squeezes out the laundry during washing, due to the following factors:

• the mode "without spinning" is enabled;
• the switch "turn off" does not work;
• damaged engine or heating element (they should be replaced).

Noises

If the machine vibrates and very noisy when spinning or the engine hums without rotating the drum, often required replacement of worn bearings. They are closed with glands and located on the axis of the drum. When water penetrates under the gland, the bearing fails.

Masters who change this part perform the following procedures:

1. 1. Disconnect the device from the network.
   2. Drain the water.
   3. Remove the external panels.
   4. The drive belt, springs, pipes, thermal sensor and counterweight are disconnected from the tank.
   5. The tank is disconnected, the pulley is removed from the drum.
   6. Bearings take along with the axis of the drum and disconnect them from each other.
   7. Install new bearings and assemble the car.

Extraneous noise can also produce one of three factors:

1. Jamming of the object between the drum and the tank (it should be removed).
2. Poor pulley attachment (requires tightening the bolt).
3. Drive belt

To correct the situation with the belt, the washing machine is unplugged and drained. Then perform the following actions:

1. Remove the back cover.
2. If the belt, worn on the pulley and the motor, is torn or worn, it is pulled over by itself while simultaneously rotating the pulley.
3. A new belt is put on the engine shaft first.
4. The pulley is rotated, pulling the belt over it.
5. Straighten the edge of the belt, so that he sat tightly in the slots.
6. Carry out test start of the car.

Electrical elements

The cause of any malfunction may be a malfunction of the electronic module or a short circuit of the triac controlling this element. The burnt triac is changed, the tracks are “soldered” on the electronic module.In some cases, a module replacement is required.

Indicated washing machine faults Zanussi can be corrected by yourself, but only if you know a little bit about electrical engineering.