Causes of washing machine door jamming and how to eliminate them

The sudden failure of home appliances always takes us by surprise: unforeseen circumstances beat us out of the usual rhythm of life. There is also such a situation, when the washing is over, the spin mode has passed without any complaints, but there is no possibility to get the laundry - the door of the washing machine does not open. You can not try to open the boot hatch with the use of physical effort, you need to calm down and establish the cause of this incident, and then try to fix it.

Causes of jamming

All modern household appliances for washing are equipped with automatic equipment that blocks the hatch from accidental opening during washing.The reason that the door does not open after washing can be late operation of automation.

When the whole process is over, a few minutes should pass, and the machine will work, the door for loading the laundry can be opened without any effort.

Sudden light off

During the wash there was a power surge or turned off the light. You heard that the machine stopped and came to pick up the washed laundry. The hatch at the washing machine does not open, because the washing process is not finished, and the automatic lock locks the door.

You need to check the automatic power-off switch in the house or wait for the supply voltage, then put continuation of the regime or spin. The machine will continue to work, and after the end you will quietly open the hatch.

Water left

One of the reasons why the door of the washing machine does not open may be that there is water in the tank, so the machine locks the door. Look in the hatch: if there is water, it means that some kind of breakdown has occurred. It is necessary to eliminate it, drain the water, and the automatic unlocks the door.

Broken handle

This happens very rarely, but we consider all options. Handle in case of breakage will hang in free positionand the lid of the washing machine’s laundry does not open. In this case, the pen must be replaced.

Many try to make a replacement on their own. Please note that after your intervention, you may have to change the hatch with the locking system.

Is the handle in good condition, and the door does not open? Lock malfunction, you must call a specialist.

When you need a specialist

Worn lock

If the door does not open, then maybe lock mechanism Broken due to wear, so you can not open the door. In this case, you need to contact a repair shop for help.

Electronics fault

Maybe, water level sensor gives incorrect data: the water is drained, but there is no signal to the control system about its absence, therefore the door is locked. It is necessary to change the sensor to serviceable.

If the hatch of LG, SAMSUNG, Bosch washing machines is blocked, then it is best to contact the original source - the attached instructions, there are all the necessary recommendations.

Fault module UBL

He gives the signal to open the hatch after the end of the washing mode. If the UBL is faulty, the washing machine does not open. There are cases when the lock itself is working, just the automatic does not give a signal to open it.

Correct solution:

• flash control board if the module is electronically controlled
• reset all programmer values ​​when it is of electromechanical type.

These actions are performed only by specialists.

Independent replacement of UBL

When the question arises: what to do if the washing machine does not open after the end of the wash, and the diagnosis has shown that the culprit is the UBL, then many users replace it themselves.

If you are really confident in your knowledge of technology and the ability to carry out small repairs without negative consequences, then proceed, but you need to adhere to such action algorithm:

• remove the securing rim to release the hatch sealing cuff segment;
• the device is fixed with the help of two screws, unscrew them to remove it;
• Install a valid UBL, perform the reverse of the dismantling action.

Tip! Take a photo before disconnecting the wires so that you can easily restore the connection system.

After the replacement work, turn on any mode and test the equipment.

Open the door

We found out the reasons for which the door in the washing machine does not open, but now we need to open it and take out the washed laundry. Before this, make sure that there is no water in the drum, so as not to flood the neighbors.

To correct unlock the door, you can use the recommendations in the attached instructions for each product, or proceed as follows:

1. Disconnect the home appliance from the network.
2. Open the flap, where the drain filter is located: it is located at the bottom of the machine. Check if there is cablepainted orange. We pull for it without undue effort - the door of the machine should open.
3. If there is no emergency cable, then remove the top panel, tilt the machine back. The drum due to its own weight will move away from the wall, and in the gap that appears, you will need to grope retainer and open it by shifting to the side.

If you doubt your abilities, then it is better not to try to unlock the hatch yourself - entrust it to professionals.

A simple solution

Why does the hatch not open, although all washing modes are finished? As we have said, there are quite a few answers to this question - there are objective reasons as a result of the failure of mechanical components or automation.

Each time it is necessary to carefully diagnose, before you come to some solution. In conclusion, I would like to suggest a rather unique way of unlocking, when the door still does not open in the washing machine after the completion of all the washing modes. Watch a short video, and everything will become clear to you:

Malfunction prevention

There are not so many tips, but they need to be constantly implemented:

1. Take care of household appliances, make the closing and opening of the hatch for loading laundry to be done gently and effortlessly, so that you do not have to spend money on repairing the locking mechanism.
2. Never overload the machine, automation has a strict program: it will not allow you to even close the door in this case.
3. Immediately pay attention to the occurrence of faults: for one will go a whole series of failures, and repair may require greater costs than replacing small parts.

When implementing these simple recommendations, household appliances will serve according to the assigned resource, without causing trouble and unnecessary problems.