Remove the pump in the washing machine Indesit

One of the most frequent problems with the operation of a washing machine is the breakdown of the pump. You can fix this problem yourself, but for this you need to be able to disassemble the equipment. Consider a specific example of how to properly remove the pump from washing machine indezit. In the models of this manufacturer, this repair is made quite simply.

Pump location

The pump is located at the bottom of the washing machine. At the same time, the bottom of the SMA Indesit is practically open or covered with a plastic lining. All elements are easily accessible, and it is enough just to remove the pump from its seat, having done preliminary preparatory work and disassembly of excess hoses.

Preparatory work

Washing machines with a faulty electric pump often do not completely drain the water, so before starting work it is better to prepare a containeron the floor lay a cloth or film.

To maximize water drain, you need to unscrew drain hose from the sewer inlet and place it in an empty container, such as a basin or large bottle. Next, you need to tilt the machine in different directions, so that all the remaining water flows out of it.

In some models, some of the water remains in washing powder containers. Before repairing it you should definitely take it off.

Drain pump (inside view)

Dismantling pump

Having prepared the place and the washing machine for repair, we begin to disassemble it for access and replacement of the pump. For work you need a wrench, as well as a cross and a flat screwdriver. All work must be done in the following order:

1. Remove the plastic panel covering the bottom of household appliances. In some models it is not, then we start withdrawing immediately from the second point.
2. Turn off the pump by disconnecting all the wires.
3. Unscrew the mounting bolts of the pump.
4. Carefully turn down the latch.
5. Before removing the pump should mark it with a marker position. When reassembling it is important that everything is assembled in the same manner and in the same position. The location of all elements is best photographed, then you just can not go wrong.
6. After removing the pump, we clean the seat of glue and dirt. This will make it easy to put everything back in the assembly.

Change the pump

When replacing the electric pump is to choose exactly similar model. Otherwise, the washing machine may not work correctly. If you cannot find the exact same pump, then select a similar pump. Often there are interchangeable analogues with newer models. When searching for a pump you should pay attention to the following parameters:

• choose a pump with similar connectors for connection;
• pay attention to the connection of the hoses, if necessary, you can put elongated hoses or shorten the standard ones;
• choose a similar mounting case in the washing machine

Replacing the pump, it is necessary to repeat the process in the reverse order, and put everything in place. With the right approach, the washing machine will work in its normal mode.

Repair without replacing the pump

Sometimes after removing the pump it becomes clear that there is no need to change it to a new one. Enough to restore performance clean the pump. To do this, it is necessary to unwind its body, free the impeller from the debris and after assembly, check for operability. If the impeller is working, then it should rotate without problems.As a rule, hair and remnants of dirt fall inside the case. In addition, the pump may stop working due to hard water or improperly chosen detergents.