Dishwasher door does not close

Improper operation of the dishwasher raises many questions. The most common one is: why doesn't the dishwasher close?The open door blocks further operation of the device. Let's try to figure out where this problem comes from, and what methods will help troubleshoot the problem.

Faults

To detect damage, first unplug the appliance from the electrical outlet. After shutdown, proceed to its inspection.

If the dishwasher does not want to close on first use after purchase, do not worry. If you have a manufacturing defect, you should contact the store where the equipment was purchased.

Sometimes this situation can occur due to improper installation of the dishwasher.

If problems with door locking occur after a long time using the device, the reasons may be as follows:

1. Deformation of the rubber seal.The solution is quite simple - replacing the seal will save the dishwasher.
2. Malfunction of the lock. If the dishwasher does not close, one of the reasons for breakage is a lock. It can either completely fail or, for some reason, shift. In any case, the faulty mechanism must be repaired or replaced.
3. Sometimes the cause is an improperly placed dish or container for it. Perhaps when loading the container was installed incorrectly, or cutlery interferes with closing the door.
4. Warping or changing the level of the door as a result of careless operation. Built-in sensors block the operation of the device. Master will help you to adjust the level.

Do-it-yourself troubleshooting

In the event that your dishwasher does not close when it is first turned on, check its connection to the electricity supply and plumbing. Even the slightest disconnection of a hose or wire can affect the operation of the device.

And for those who are faced with a problem during operation, you can try to change the seal or lockby myself. To change the seal will need to purchase it in advance in a special store.

Pick a rubber seal specifically for your model.Universal pads can not always ensure the correct operation of the device.

When self-replacing the seal, you must first remove the old gum. Now you should place the new seal precisely in the “groove”. If the length of the new gum was slightly longer than necessary, simply cut off the extra piece with scissors.

Now go to repair or change the lock. The first thing to do is unscrew the bolts around the perimeter of the door. It is very important to maintain the panel in order to avoid breaking the wires. If there are no major defects in the lock, return it to its original position with pliers. Screw the bolts back and check the operation of the device.

The task, how to close the door of the dishwasher, is still relevant? Change the lock. Be careful: changing the lock on different models of machines can be difficult even for an experienced user. Therefore, again, to prevent any other damage, you should contact a specialist in repair. 

Conclusion

There are many reasons for malfunctioning a dishwasher: from improper connection to breakage of electronics.You can try to find out the cause yourself, but it is still better to contact the repair service. So you will save the device from accidental damage and incorrect intervention in its work.