Technique of the new era: oxygen balance heaters

In matters of heating, many people, for a variety of reasons, make the choice in favor of electric heaters. However, some of these devices have a significant drawback - they dry the air. Due to the operation of the helix, the oxygen in the room becomes too dry and unhealthy. About 60% of moisture is lost. We have to constantly ventilate the room, thereby releasing heat and money outside, not to mention the risk of getting a cold from drafts. So what kind of heater from the entire rich range does not dry the air?

Answer by contradiction

First, let's look at what the heater looks like, which dries the air. They steal moisture from an open spiral appliance, air heaters, fireplaces. In addition, these devices burn dust, thereby triggering the release of toxic gases. But this technique is already the last century, it was replaced by heaters of a new generation, possessing a number of advantages.

Today, production technology has reduced the percentage of oxygen burning to a minimum.

Best of all, the following innovative heaters keep the balance of moisture and heat;

• infrared;
• oil;
• ceramic;
• vapor drops;
• quartz;
• convector;
• mikatermicheskie.

Infrared heat rays

These heaters operate on the principle of short and long waves of infrared radiation. Rays, imitating the sun, give energy to things and objects in the zone of their location.

The work of infrared rays is based on the heating of surfaces, not air. Therefore, the equipment has no effect on the quality of the humidity.

Infrared heaters spend a small amount of electricity. Fit for large rooms. Warm up things keep warm for a long time even after turning off the device.

Oil batteries

The heater looks like a regular battery. Heat is obtained by heating the oil, which is located inside the accordion.The air in the room warms up slowly and remains moist. The heating temperature can be adjusted. Oil batteries are working silently.

However, oil heaters have two significant drawbacks - they are unsafe and energy consuming.

Heating the oil, the radiator becomes hot itself. During operation, the device must not be touched and left unattended. The second drawback is inefficiency. The heater takes time to start to give off heat, but it consumes electricity immediately and in large quantities.

Ceramic panels

Ceramic heater - the first in the list of devices that do not burn air. It works due to long-wave infrared radiation. Waves warm objects and air. Made in the form of a panel, which allows you to hang it on the wall, but this is not at all necessary - the technique functions perfectly on the floor.

The heating element is covered behind a ceramic shell, so it does not violate the composition of oxygen in the house.

For higher heat transfer on the panel ceramic heater do embossed surfaceIt also prevents air drying.

Steam drop heaters

Drip heater different from other heating devices. In its system there is water that is heated during operation of the device. Water boils and turns into steam, which in turn gives off heat, goes into the condensate and flows into the drip heater.

The structure of the heater itself not only does not dry the air, but, on the contrary, serves to humidify it.

In addition, the vapor-droplet device economically consumes energy, and when disconnected from the network it keeps heat for a long time.

Technique of quartz

Quartz view technology also applies to infrared heat sources, therefore, like other types, does not dry the air.

The heater is operated by an incandescent filament placed in a quartz tube. The surface of the filament does not heat up to temperatures that affect air quality.

This does not interfere with the quartz heater effectively heat everything that falls under the infrared rays.

Convectors

Convectors function thanks to heat transfer: cold air flows through the grate at the bottom of the device, and after passing through the radiator, it comes out, heated to the desired temperature. The degree of heat is set using a special sensor.

Lack of the fan, allows air to leave freely, without thereby violating the humidity of the room.

At the same time outside the heater is not heated, which eliminates burns. Depending on the type, the convector device can be hung on the wall, put on the floor or to build in the window sill.

Micatermic Heaters

Also refer to infrared emitters, only, unlike the devices described above, its waves are much longer.

Micatermic Heater - a new development, before such technologies were used only in medicine and in the space exploration industry.

At the heart of the structure of the apparatus are plates of metal, covered with a transparent layered mineral. This technique applies to energy saving devices, therefore, like other infrared means of heating, do not eat up oxygen. The heater is suitable for placement both on the wall and on the floor.

Purchasing a heat source, first of all, should check all its functions. To do this, be sure to turn on the heater in the outlet and wait until the heating process begins.It will be useful to find out from the seller about the protection from power surges. In the case of a purchase, ask about the issue of repair and the possibility of exchange. But in order to insure yourself against unpleasant situations, you must clearly follow the instructions for use of the device.

The models of heaters listed in the article have different costs, but they all belong to the instruments of the new period. They are designed not only to fill the house or office with heat, but also to preserve the natural balance of oxygen. However, they are much more expensive than conventional, air-drying heat sources.