Why does the powder remain in the machine after washing?

It so happens that by running the wash in the simplest mode, you find after the end of the wash in the detergent tray. This can happen again with air conditioning. If before the machine worked perfectly, then you should not worry. It might not be very difficult to fix this problem. So, why does a powder sometimes remain in the washing machine?

What is the principle of the powder from the machine

Most machines are equipped with trays for detergents and air conditioners that can be extended. The capacity of any machine has several divisions (usually three or four), intended for different wash cycles. There are usually three of them. In the first compartment, the means for pre-soaking is poured, in the second, the means for starting the main wash,but the third is for a liquid conditioner.

There are two different types of trays: with one inlet valve and with several. Tanks of the first type are in mechanical devices. They work is incredibly difficult: the water in the departments moves due to the presence of special mechanical devices. The flow of water during washing is controlled by guide element. Its breakdown is the main reason that the washing machine does not pick up the powder. This happens because during the beginning of the main cycle the water goes through the first compartment, and the powder of the second remains intact.

Washing machines, which are manufactured now, are equipped with electronic control, such devices work much easier. They have several solenoid valves, which control the water supply to all compartments of the tank. If the powder remains in the tray, the reason may be valve breakage.

The most common causes of the problem

Panic ahead of time is not worth it. The reason why a washing machine does not pick up powder may not be a breakdown at all. The first thing you should do is figure out what is going on.

1. 1. Does the water flow into the machine or not? Maybe it turned off? Or did you forget to turn the supply valve after the holiday? Or turned, but not Donets, and the flow is very weak. Some models of machines in such cases do do not start, others - stop in the middle and give an error.
   2. Maybe the water pressure is very weak? Clogged pipes are a common cause of this. This can happen both in the whole apartment, and only at one point.
   3. Did you put powder in the right compartment? If the machine is purchased recently, you should read the instructions very carefully. Also, some owners fall asleep cleaning agent in the department, designed for prewash. Because of this, when you start a regular program, the powder has to stay in place. Here You can read about where to pour funds for the typewriter.
   4. Another possible reason - the clogging of the channel wash washing machine. If the device is old and the container has never been reached or washed, the powder may remain because of this.
   5. It is possible that you fall asleep without the use of special dispensers, for example, a measuring cup or measuring spoon. Sometimes the powder is too much, it is broken. recommended dosage. Remember that the laundry will not be better to wash off from a large number. High-quality detergent - that's what's important.
   6. From the fifth point follows the sixth. Laundry should be done using quality powder. A bad remedy becomes lumpy and sticks to the container walls, remaining as a result in the compartment.

If this is not the problem, then you should think about the diagnosis of the device in the service. The reason that the device does not pick up the powder may be banal washing machine breakage.