How to easily increase the power of a vacuum cleaner with your own hands

In the process of active use of household appliances, situations may arise where their performance is no longer sufficient for comfortable use. This is especially noticeable in vacuum cleaners when it becomes impossible to finish cleaning properly. In this case, you need to know how to increase vacuum cleaner power. Consider a few ways to do it yourself.

How to increase power without turning to professionals

If the efficiency of the vacuum cleaner gradually decreases over time, you can eliminate it yourself. two reasons such his behavior. These include:

1. Incorrect or loose assembly of parts of the device.
2. Clogged filters.

If the device is assembled incorrectly, and it does not have the protection function from improper assembly, then the device can simply work with less effectiveness.

If the parts of the unit are installed loosely, then the additional intake air will significantly impair the operation of the device. The increase in power in these cases is possible after disassembly and subsequent proper high-quality assembly of the unit.

Be sure to check the filters of the vacuum cleaner, it is they most often cause a decrease in its absorbability.

In various models of the device there may be up to 4 filters, and you need to check the status of each of them. Depending on the type of filter, it may need to be replaced or just dry or wet. cleaning.

In models with a dust bag you need to check the integrity of this bag, be sure to clean it, and then reinstall it. With devices with an aqua-filter, you need to pour out the water and rinse the container (for more details on the maintenance of the devices -eternal vacuum cleaner, or the rules of care for household appliances).

What to do with a sharp change in power

If, during the cleaning process, the efficiency of the suction of the unit dropped abruptly, then, most likely, the cause will be the object stuck in the tube. To solve this problem is very easy. It is necessary to turn off the device and check the condition of the tube.When a piece of paper, a small toy or other object is detected, it is enough to remove it, and the device will work properly again.

However, such a situation may also occur when, during cleaning, the power switching lever on the device case was accidentally touched. If this is true, then it is enough just to return the lever to its previous position.

In addition, the tube also has a lever that controls the absorbability of the device. Perhaps this lever was accidentally pressed, and a hole was opened, where excess air began to be sucked in, which also reduced the efficiency of the device.

Having corrected all these moments, you can continue cleaning in the planned mode. If all these measures have not received the proper response of the apparatus, then it will be necessary to seek the help of qualified specialists.