Why the dishwasher doesn’t always turn on when you first start

Before you turn on the dishwasher and use it for its intended purpose, carry out the first test run. Such a measure is needed to verify the proper operation of the device, debug connections to communications and disinfect the internal drum.

Preparation for testing

Before you start a new household appliance, make sure that it is properly installed and connected to the water supply, even if it is not the first dishwasher you are dealing with.

1. The device must be installed on a solid, solid surface. Minor deviations in slope level may cause unnecessary noise, as well as incorrect work.
2. A hob can not be installed above a built-in dishwasher: it can release excessive heat and magnetic waves.
3. It is not recommended to use extension cords when connecting the device to the mains. Make sure the outlet is working and the wire does not heat up when turned on.
4. Check the water supply hose, if possible, install an additional filter. Water supply valve must be in good condition so that in case of leaks it is possible to quickly shut off the flow.
5. The door of the machine should close with a characteristic click, the impeller should rotate smoothly and steadily.
6. Salt and detergents fall asleep in special compartments.

First power on and possible malfunctions

Be sure to read the instructions for the device, it contains information about the main nodes, a description of the buttons on the panel and possible errors with the decoding. For a trial run, manufacturers recommend using a special tool: a cleansing powder will help remove traces of glue or grease inside the machine, from baskets and trays. By the way, it is quite inexpensive. If all the manipulations are done correctly, the dishwasher will run a cycle without problems.

You can choose any program for testing, but it is recommended to set the standard washing mode.

It should be understood that any equipment, including a dishwasher, does not always work correctly. In particular cases, there are problems - for example, the device does not start (or does not turn on), “freezes” in the middle of the cycle, makes sounds, and in the worst case, there is smoke or the smell of burning plastic. What to do if the launch is not made, or the device is not stable?

1. If the scoreboard appears error code, or some lights blink - read the instructions for which node they are responsible.
2. The dishwasher may not start when there is no connection to the electrical grid, the cord or outlet is faulty, there are leaks or water does not flow into the hose at all. If no item is appropriate, the device may be defective.
3. When white or dark smoke appears, burning plastic smell, immediately turn off the device and contact the service center. This fact means that there are serious problems with the assembly; here you can count on warranty repairs and even a complete replacement of the machine.
4. A “freeze” in the middle of a loop usually means a failure of the electronics or programmer. Unplug the appliance for 10-15 minutes and try again to turn on the dishwasher.If the error is repeated three or more times in a row - professional diagnostics are necessary.

Note! Before buying carefully read the warranty card and the conditions for the provision of warranty repair. Not all trademarks are conscientiously responsible for the operation of the devices, and the warranty may apply only to certain parts (or even one).

Major brands such as Bosch (Bosch) ensure availability service center in most cities. If necessary, you can contact a specialist with a question by phone or call the master at the house.