Why e-cigarette flows

Why are the vapes flowing? This is an actual problem for bathers using devices from different brands. When an electronic cigarette flows, then a number of unpleasant consequences are manifested: an insufficient amount of steam can be generated, liquid gets into the mouth, there can be squelching sounds during puffs. Due to the fact that a liquid is leaking, there may even be a short circuit. Often the problem with the fact that flowing vape, it is easy to fix on their own and at no extra cost.

Content

1 The causes of the phenomenon and their elimination
2 Recommendations for the correct use of vape

The causes of the phenomenon and their elimination

A modern electronic cigarette is a high-tech product that often does not resemble traditional tobacco products in appearance. In simplified form, it consists of battery pack and atom. Today 3 types of evaporators are used:

clearomizer;
serviced option;
dripka

Flowing vape

Vapes of different models flow, for example, Ijust s, Kangertech subox mini-c. The main reasons for the tank leaking when tilting are presented in the table below.

№	Cause	Remedy
1	The use of low-quality device.	You should use products known, proven brands or pre-read online reviews about the purchased device.
2	Use for steaming liquid (slurry) of inadequate quality (low viscosity).	1. Use slush from reputable manufacturers. 2. It is possible to bring the viscosity of the liquid used to the desired level using adding glycerin.
3	Overheating of the steam generator.	If an overheating of the evaporator occurs, stop the evaporation for a few minutes to cool the atomizer.
4	Incorrect tightening when hovering (reinforced).	Tighten steam should be smooth, not too deep.
5	Low battery charge.	It is necessary to constantly maintain the battery in a charged state.
6	Evaporator failure due to deterioration (aging) or improper operation.	Replacement of the steam generator.
7	Clogged ventilation openings.	Timely, periodic cleaning.
8	Wrong, untimely care of an electronic cigarette during operation.	Regular preventive maintenance vape, compliance with the rules of operation set out in the instructions.
9	Inappropriate settings.	In devices with adjustable power set the required value.
10	Manufacturing defect.	If the device is located on guarantee - it can be replaced with a new one, and in case of its absence - it will be necessary to independently acquire a new device.
11	Inadequate tightening of parts along the thread.	It should tighten them stronger.
12	The presence of cracks on the glass or dents on the metal (mechanical damage).	Replacement parts.

Also, the tank under the liquid flows due to temperature changes and pressure fluctuations, heating from heating devices or sunlight, the formation of condensate. In such cases, these factors are simply avoided.

If after the manipulation of the ES is still flowing, you need to contact a specialist.

Often the reasons that an electronic cigarette is leaking are precisely the improper use and maintenance of the device. Most of them are easy to eliminate, only in rare cases will you need to purchase a new product.

Strong leak in electronic cigarette

Recommendations for the correct use of vape

In order for the electronic cigarette to last as long as possible, it is necessary to use it correctly and to carry out regular preventive care. Tips for using Ijust s or any other model are listed below.

Should not be allowed evaporator overheating when soaring, it should be allowed to cool for an average of 10 minutes.
It is necessary to pull in steam without effort, slowly.
It is required to constantly monitor battery charge level and do not use the device at its minimum.
It should periodically disassemble the electronic cigarette and clean. In this case, the important point is the correctness of all the manipulations for the model used.
It is not recommended to store the mod near the radiators or under direct sunlight.

New fluid for soaring in the tank should be filled only after it is empty (it is better to also rinse) and strictly in the recommended volume instructions.
During refueling you need to close the airflow.
Density of used slurry must comply with the recommended.
In winter, it is not recommended to soar after leaving the house for about 15 minutes, it is desirable to wait the same time after returning. This time is needed to “acclimatize” the device.
Worn out sealing rings (o-rings) need to be replaced regularly.
The device must be in a vertical position during storage.
It is necessary to carefully handle the electronic cigarette to avoid mechanical damage.
Do not forget to tightly close the tank.
Also need to pick optimal amount of wool for the spiral at the first independent rewinds.

It is necessary to do prophylaxis regularly with periodicity once a week.

Electronic cigarette requires timely and proper care. Very often, liquid flows out of it in case of improper operation. The acquisition of devices of well-known brands, the use of high-quality slurry, the periodic replacement of consumables, the maintenance of the temperature regime - this is the key to a long product life. Soaring an e-cigarette is considered less dangerous than smoking tobacco cigarettes.But still it should be borne in mind that with the regular intake of nicotine into the body, it is poisoned, and health becomes worse.