How to properly disassemble the remote from the TV

Very often when using the remote control may occur various problems. For example, buttons began to work badly or stick. Such troubles can be corrected independently, the main thing is to know how to properly disassemble the console, for example, from samsung tv.

What you need to perform

It is worth noting that there is no significant difference when disassembling devices of various brands, since the remote control devices Samsung, Sony, Philips, LG There are no fundamental differences in the design. Most often, the consoles differ only in size, location and design of the keypad.

Next will be considered the general principle of parsing the console for cleaning. For other purposes, the wizard does not recommend to disassemble the device: repairs requires some knowledge of the principles of the structure and functioning of microcircuits, which not everyone has.

To avoid difficulties with the question of how to disassemble the remote control from the TV, you should prepare:

• small Phillips screwdriver;
• non-sharp kitchen knife or flat screwdriver;
• plastic card.

Each of these things may be needed at some point.

Sequencing

The process of disassembling the console is quite simple, and every owner can cope with it if it is necessary to clean the device in case of malfunction.

1. Initially, it is worth conducting a careful inspection of the remote control. You need to search for all possible fasteners. It is worth noting that quite often manufacturers have one of them in the battery compartment.
2. Then, with a screwdriver of the appropriate size, all fasteners are unscrewed.
   

3. Now you need to make sure that the assembly is not used. special glue. If the gluing was not performed, then you should press on the sides and insert a plastic card into the turned hole, and then hold it around the perimeter, opening the case.This should be done very carefully so as not to damage the edges of the case and the inside of the remote control device.
   
4. If the parts of the body are glued together, then a kitchen knife or a flat screwdriver is required to open it, and they are held around the perimeter of the whole body, and only then opened using plastic card. When assembling the remote should also use adhesive bonding.
   
5. After the top case cover is removed, you can unscrew the chip.
6. From the front cover side, remove the keyboard and clean it. swab dipped in alcohol. This will help get rid of the sticking of the buttons and make it easier to press.
   

7. Experts recommend not to disconnect the sensor from the chip.

After all the elements are cleaned with alcohol, you can begin to assemble the remote control in reverse order.

If during the inspection it was possible to establish that the cause of the failure of the console in a burnt-down chip, then you should not look for a new one - it is much easier and simpler. buy a new device. After all, today, popular manufacturers such as Sony, Samsung, Lg, Philips, sell remotes separately from the TV.There are even universal remote controlssuitable for various devices. The cost of repair may be higher than the price of a new device.

Features disassembly touch panel

The principle and sequence of work is the same as for the push-button version. It is important to choose the right screwdriver, and after removing the case, carefully detach the touch sensor located under the keyboard. All actions and movements must be very careful not to damage the surface of the sensor and cables that connect it to the board.

The best solution in case of breakdown or poor quality work of the touch panel will be an appeal to a specialist.